品牌：RETZ瑞茨/美國，我們一直致力于流體控制領域的持續創新，始于2005……

功能：控制管道系統壓力，消除管道多余壓力，使系統的壓力保持在預先設定的壓力點上，確保管路系統安全運行。

Function: Control the pressure of the pipeline system, eliminate excess pressure in the pipeline, maintain the system pressure at the pre-set pressure point, and ensure the safe operation of the pipeline system

應用區域：建筑、水處理等。

進口安全泄壓持壓閥產品詳情 Product details

泄壓持壓閥、緊急開啟閥在傳動方式上采用了水力操作并能自動控制，即利用控制管路中的壓差自動開合，關閉主閥，使上游的壓力不超過某一設定值。閥體采用了全通道流線型設計，流體阻力小，密封性能好，自動啟閉性能靈敏。該閥的主要特點是既可以作泄壓閥，又可以作持壓閥。

The imported pressure relief and emergency opening valves adopt hydraulic operation and can be automatically controlled in transmission mode, that is, use the pressure difference in the control pipeline to automatically open and close, close the main valve, and ensure that the upstream pressure does not exceed a certain set value. The valve body adopts the full channel streamline design, with small fluid resistance, good sealing performance, and sensitive automatic opening and closing performance. The main feature of this valve is that it can be used as both a pressure relief valve and a pressure holding valve.

進口安全泄壓持壓閥工作原理 Working principle

1.作泄壓閥時：可將水管中超過先導閥安全設定值的壓力釋放，并維持管中壓力于一定安全值以下，以防止管中高壓或突壓毀壞管線設備

When using a pressure relief valve: it can release the pressure in the water pipe that exceeds the safety setting value of the pilot valve, and maintain the pressure in the pipe below a certain safety value to prevent high pressure or sudden pressure in the pipe from damaging pipeline equipment

2.作持壓閥時：可維持主閥上游供水壓力于某一設定直以上，以保障主閥上游的供水壓力

When acting as a pressure holding valve, it can maintain the upstream water supply pressure of the main valve above a certain set point to ensure the upstream water supply pressure of the main valve

3.作緊急開啟閥時：裝于消防噴淋泵出水口處，當泵出水口處壓力上升某一設定值以上立即開啟

When acting as an emergency opening valve: installed at the outlet of the fire sprinkler pump, immediately open when the pressure at the pump outlet rises above a certain set value

技術參數：

公稱通徑：DN50~DN500

適用溫度：0℃~80℃

***小壓差：0.1MPa

液面控制高度：≤150mm

壓力等級：PN10（調節范圍0.3-0.9Mpa）

          PN16（調節范圍0.5-1.4Mpa）

          PN25（調節范圍0.5-2.4Mpa）